Author Topic: The Indigo room (Read 76795 times)

stormcloud · « **Reply #75 on:** August 20, 2008, 09:42:47 PM »

well I nearly got it right, just the wrong temperature change

Jubal · « **Reply #76 on:** August 31, 2008, 06:10:13 PM »

I need to come up with another room...

Jubal · « **Reply #77 on:** September 05, 2008, 04:21:06 PM »

THE DIAMOND ROOM

Shiny!

The room's floor is half paved in diamond... and you can even see an open door on the other side! However, on the other half of the floor there is a checkerboard of square steel plates about the size of your foot, and squares covered in large, sharp, deadly looking spikes. Also, across the middle of the room, at about waist height, there is a belt-action, diamond coated bandsaw belt, running at full power. How the hell are you going to get out of this one?

P.S. Look back through the rooms - this room will not solve itself.

stormcloud · « **Reply #78 on:** September 05, 2008, 04:31:39 PM »

I get the table from the azure room and the bars from the door in the grey room and use them as a bridge over the spikes

Jubal · « **Reply #79 on:** September 05, 2008, 04:49:45 PM »

Clarify? How do you get past the saw belt?

CN2 · « **Reply #80 on:** September 05, 2008, 05:31:34 PM »

I throw the fridge at it.

stormcloud · « **Reply #81 on:** September 05, 2008, 06:58:40 PM »

I dont know how tall the table is but most are above waist hight, so it could be used as a bridge

CN2 · « **Reply #82 on:** September 05, 2008, 07:04:07 PM »

couldnt you just crawl under it(Unless im thinking of a different saw) you can just crawl under it carfully and not step or place your hand on the spikey tiles.

Jubal · « **Reply #83 on:** September 09, 2008, 05:18:34 PM »

The table is about the same height as the saw, not big enough to go right over it though.

Due to the shinyness of the room, you didn't notice the laser beams going across under the saw. Sorry CN2.

Also you can't move the fridge - we bin through this one.

stormcloud · « **Reply #84 on:** September 09, 2008, 06:59:45 PM »

how tall are the spikes on the panels?

CN2 · « **Reply #85 on:** September 09, 2008, 07:10:41 PM »

30 inches

is there anything that we can throw at the saw?

Jubal · « **Reply #86 on:** September 09, 2008, 08:18:47 PM »

Not that won't get cut into lots of tiny little bits, no.

stormcloud · « **Reply #87 on:** September 09, 2008, 11:14:36 PM »

erm, height of the spikes?

i look for a control box for the saw

Jubal · « **Reply #88 on:** September 10, 2008, 08:23:22 PM »

10 cm above floor level, but depressed into the floor, they're about 30cm tall in total.

No control box can be found.

stormcloud · « **Reply #89 on:** September 10, 2008, 10:07:42 PM »

ok I stand on the table and throw down the bars to make a safe landing area jump over the saw and onto this area and proceed to either tiptoe between the spiked tiles or use the bars as stepping stones and make my way to the next room (or freedom

)

News:

Author Topic: The Indigo room (Read 76795 times)